220V Stainless Steel Solder Soldering Pot 300W 100MM Desoldering Bath 1200g New

Description

siafort
AC 220V 300W 100MM Electric Solder Pot Tin Melting Furnace Casting Pouring Crucible
DESCRIPTION
Product Dimension:
Feature:
1) Using high quality stainless steel solder pot, with a high temperature, acid, abrasion resistance, non-stick tin, tin oxide surface less so.
2) Temperature can be adjusted according to requirements
3) Easy to use, good thermal effects, tin melting fast
4) Less power consumption, energy saving, long life
5) New electronic thermostat circuit design, the working temperature from 200-480.
6) Initial use tin stove, electric core of a small amount of smoke is normal
SPECIFICATIONS
Condition:
100% new
Color:
Blue & Gold & Yellow & Red & Black
Material:
Stainless Steel
Total Size:
approx.21x13.8x7cm(8.27x5.43x2.76inch)(LxWxH)
Tin Pan Inner Diameter:
approx.10cm(3.94inch)
Capacity:
1200g
Molten Solder Time:
About 8 minutes
Input Voltage:
AC220V 50Hz
Power:
300W
Suitable for:
Melting solder
Item included:
1 x Solder Furnace(Included Adapter)
This Is Aftermarket Replacement Item But Not Genuine
Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Color may vary slightly due to the color setting of each individual monitor.
3) This product must be grounded. Improper installation of the grounding must be prohibited.
4) Position the control dial to high range when you start to use the solder pot, and then place the dial to the grade of auto-temperature after soldering. The general working temperature of molten solder in the solder pot is 300-350 degree(around grade 4-grade 9). The temperature of melted solder shouldn't be too high, or it will cause the aging of solder pot, the darkening or yellowing of melted solder. When highly acidic scaling powder is applied, the solder pot is more likely to be corroded or perforated under extraordinarily high temperature.
5) Power must be turned off before leaving to avoid accidents.
On Jul-24-20 at 03:13:12 PDT, seller added the following information: